Skip to main content

Bottom bracket axle

Product information "Bottom bracket axle"

Bottom bracket axle for all 2-speed motors and 3-speed motors with left brake
Engine Typ: 2-speed, 3-speed
Models: N, S, L, Cavallino, N23, S23

0 of 0 reviews

Average rating of 0 out of 5 stars

Leave a review!

Share your experiences with other customers.


dazu passend:

Set nut and spring washers bottom bracket axle
Set of 2 nuts + 2 spring washers

€3.20*
Set nut for bottom bracket axle 1st version w. discs discs
old version up to vehicle no. 447150, galvanised

€4.80*

Similar products

Shift fork 3-G.

€95.00*
2-speed gear lever (on the engine)
Shift wheel on the engine for all 2-speed versions

€5.50*
Bolt for driving disc
Bearing bolt for driving disc on 3-speed engine

€3.50*
Bolt for gear lever
Bolt for gear lever bearing 2-speed different versions - note engine number!

From €2.90*
Bottom bracket axle Quickly F used

€59.00*
Bottom bracket axle Quickly T,TT,F23

€29.80*
Brake lever for foot brake (3-speed right-hand brake) - second-hand
Used brake lever for engines with brake output on the right

€22.50*
Brake lever on the motor
Note different versions!

From €13.20*
Brake lever retaining ring (pair)
Set of 2 for all 2 and 3-speed engines with left brake

€1.00*
Brake lever retaining rings Quickly S2, F23, S2-23
1 set of circlips for right-hand brake motor

€1.00*
Bushing for gearwheel 2-G.
Bearing bush for gearwheel 2-speed motor

€6.50*

Customers also bought

Crank keys, complete
Crank keys for bottom bracket axle or pedal crank - 1 set of 2 including nuts

€2.00*
Gasket set complete
Complete gasket set with all housing gaskets, shaft seals and O-rings +manifold gasketfor 2 and 3-speed engines

From €34.80*
Clutch kit
Clutch set for 3 or 5 disc clutch from current production. No hardened old stock!

From €14.00*
Chain sprocket
suitable from vehicle no. 20694Chain sprockets with 12 teeth are standard for all models. Depending on requirements or use, however, sprockets with 11 teeth (good climbing ability) or 13 teeth (higher top speed) can also be fitted. The 14-tooth sprocket can only be used after modifying or adapting the housing or using a weaker, non-reinforced chain.

From €17.50*
Wedge crank (pair)
Wedge crank (pedal arms) set for left and right), matt chrome-plated as original in top quality

€24.00*
Spacer tube 2-speed
Spacer tube on bottom bracket axle for 2-speed motorInstallation note: Clearance between spacer tube and large gear wheel must be 0.2-0.3 mm!

€9.50*

Customers also viewed

Driver for brake
for all 2-speed and 3-speed motors with brake on the leftOrder driver seals at the same time!

€14.80*
Connecting screw crankcase-ignition side

€0.80*
Speedometer drive 26", N,S,L - hub driver
New speedometer drive with hub engagement, stable design in top quality, like original VDO

€29.80*
Bolt for gear lever
Bolt for gear lever bearing 2-speed different versions - note engine number!

From €2.90*
Radial seal for shift shaft 3-speed
Radial seal ring shift shaft for 3-speed engines

€4.50*
Crankshaft, Sport
Full cheek crankshaft type "Sport"More power and torque with the full cheek crankshaft.Achieve optimum performance in the mid to upper speed range thanks to greater pre-compression.Very stable crankshaft with needle bearings - Suitable for all engines! More torque Better pre-compression Better filling ratio Needle bearing mounted stable up to highest speeds

€142.00*
Bottom bracket axle Quickly T,TT,F23

€29.80*