Skip to main content Skip to search Skip to main navigation

Product information "Speedometer NSU MAX"

Top quality speedometer for NSU Max
Diameter 80mm

Herstellerinformationen:
NSU Quickly und Moped Ersatzteile GmbH & Co.KG Siemensstr. 8 77948 Friesenheim WEEE-Nummer:

Verantwortliche Person:
B. Krippl info@nsu-quickly.de

0 of 0 reviews

Average rating of 0 out of 5 stars

Leave a review!

Share your experiences with other customers.


Similar products

Blind cover for speedometer holder
Dummy cover for headlights (required if no speedometer is used)

€8.00*
Bracket for speedometer
Retaining spring for fastening the speedometer(169204501)in the headlight

€7.00*
Quickly L speedometer spring retaining bracket
New retaining pin for attaching the Quickly L spring - now stainless steel!

€4.50*
Replacement chrome ring for speedometer
Replacement chrome ring, top quality for Quickly speedometers, eye-catcher for every moped

€13.80*
Rubber seal for speedometer
Rubber seal, cream white for installation between speedometer and headlight

€2.00*
Speedo cable Cavallino
silver-grey - length 700 mm, suitable for NSU Quickly Cavallino

€5.80*
Speedo drive 26", N,S - Spoke driver
New speedo drive for Quickly N with hubs 1st version.Speedo drive with spoke driver - high-quality metal design

€29.50*
Speedo drive for 23 wheels
Speedometer drive - suitable for Quickly N23, S23 and Cavallino

€19.80*
Speedometer (for installation in the headlight)
incl. rubber seal suitable for: Quickly N,S,L,N23,S23,S23-2,S2,F - not for T,TT,TT/K

€86.00*
Speedometer 48 mm (Cavallino)
New speedometer for the Quickly Cavallino

€49.00*
Speedometer cable "VDO version", type "O"
silver-grey - Length: 850 mm Connection nuts top and bottom identical

€5.80*
Speedometer cable for "Veigel" speedometers
Ausf.: original drive or Krippl drive
--original speedo drive--

Variants from €14.00*
€14.80*

Customers also bought

Nozzle needle for 1/9/1 and 1/9/16
Nozzle needle for carburettor types 1/9/1 and 1/9/16 and all types with cover screw connection (carburettors without starting device), suitableNozzle needle and needle nozzle are wearing parts and should be replaced - you will then get the best possible performance and low consumption values

€4.50*
Jet needle for starter carburettor
Jet needle for all starter carburettor versions - replace needle and needle jet with original parts for better engine running and lower fuel consumption

€5.80*
Clutch nut / pole wheel set with spring washers
Set of nuts for clutch or pole wheel, consisting of 1X nut and 2X spring washer - galvanised

€1.00*
Petrol hose, transparent, 1 m
Petrol hose, clear - new quality! - Petrol and oil resistantUnit 1 m

€3.20*
Fuel filler cap gasket
Replacement seal for all models

€1.80*
Chain sprocket
suitable from vehicle no. 20694Chain sprockets with 12 teeth are standard for all models. Depending on requirements or use, however, sprockets with 11 teeth (good climbing ability) or 13 teeth (higher top speed) can also be fitted. The 14-tooth sprocket can only be used after modifying or adapting the housing or using a weaker, non-reinforced chain.

From €17.50*
Small parts/repair kit starter carburettor - 10 pieces
Set with cover seal, float seal ring, seal for needle nozzle, clamping spring, retaining plate for nozzle needle, disc for throttle slide, 2 screws each for float housing cover and cover plate Set price

€10.80*