Bowden Cable
Special adjusting screw for the Quickly L handbrake cable
Special operating wire for bell model Quickly L, incl. matching screw nipple
Bolt for brake linkage, incl. safety catch, stainless steel - for brake linkage or cable pull
the Bowden cable set contains: 1 x throttle cable, decompression cable, handbrake cable, 2-speed gearshift cable, clutch cable
the Bowden cable set contains: 1 x throttle cable, decompression cable, handbrake cable, 2-speed gearshift cable, clutch cable
1 x each decompression cable, throttle cable, handbrake cable, clutch cable, 3-speed gearshift cable
1 x each decompression cable, throttle cable, handbrake cable, clutch cable, 2-speed gearshift cable
1 x each decompression cable, throttle cable, handbrake cable, clutch cable, 3-speed gearshift cable
the Bowden cable set contains: 1 x throttle cable, decompression cable, handbrake cable, 2-speed gearshift cable, clutch cable
1 x each decompression cable, throttle cable, handbrake cable, clutch cable, 2-speed gearshift cable
Bracket for attaching the brake cable
Rubber cable strap, as original - for fastening the cable pulls and cables coming out of the frame.Set of 2 pieces
Clutch cable for various models and versions with or without adjusting screw, depending on the variant!
Cable pull for handbrake, different versions depending on model and year of manufacture
Plug nipple for handbrake or clutch cable2 pieces are required per vehicle!
Protective conduit for routing the cable pulls and cables in the frame.
Rubber grommet on the carburettor (adjusting screw) at the top
Rubber grommet for brake cable and speedometer cable for Quickly S23, S2-23 and F23 on the front mudguard
Rubber grommet at the bottom of the frame exit to feed through the cables
f. Bowden cable guide handbrake cable and speedometer cable Quickly S or L (2 pieces are required per vehicle) also handlebar fairing TT/TTK u.Rear light cable / mudguard grommet TT
Screw nipple for attaching the decorative cable to the lever on Quickly N,S,N23,S23,F
Seal for the 3-speed shift cable on the engine (lower bushing)
2 nipples for attaching the 3-speed gearshift cable to the engine (gearshift paddle)
Sleeve for insertion between throttle cable and adjusting screw. Due to the short adjusting screw, the adjusting screw often cannot be adjusted sufficiently.This problem can be solved with this slotted sleeve.Installation:First screw in the adjusting screw completely (basic position), then pull the carburettor slide up through the throttle cable and insert the slotted sleeve between the adjusting screw and the end of the Bowden cable. The sleeve is centred when the slide is released.The idle throttle can now be adjusted again. Can also be used for other cables, such as the handbrake or clutch cable.
Complete cable -incl. top pipe bendPlease note the different versions (model or frame number/carburettor type) and select accordingly!The adjusting screw and rubber grommet on the carburettor are separate parts (see carburettor group),please order separately if required