Gasket set

Product information "Gasket set"
Four-part gasket set for the Quickly engine.
Consisting of cylinder head gasket, cylinder base gasket, crankcase gasket and clutch cover gasket.
Ausf.: 2-speed, 2-speed,
Engine Typ: 2-speed
Models: N, S, L, N23, S23

0 of 0 reviews

Leave a review!

Share your experiences with other customers.


Similar products

Screw set for motor housing
Complete screw set for bolting the housing halves of the NSU Quickly engine -- 8 screws + washers -- Select version according to engine number or surface

From €5.80*
Crankcase gasket
Gasket for engine centre 2 or 3-speed engines

From €3.60*
Circlip TT-K / F23
Locking ring for Quickly TT-K for kickstart spring or for Quickly F23 swing axle

€1.00*
Oval-head screw for rear chain guard

€1.20*
Alternator side cover
Note different versions! for all 2-speed and 3-speed models with brake lever on the left-hand side of the motor: Quickly N, S, L, N23 and S23 or version for engines with brake lever on the right: Quickly S2, S23-2, F23, TT, TT/K

From €39.80*
Ball bearing for crankshaft
Ball bearing for crankshaft (quality from FAG) 2 pieces are needed!

€6.50*
Crankcase centre section
Crankcase centre section for all 2- or 3-speed engines for 2-speed only used, for 3-speed also available as new part, please select accordingly on the scroll bar

From €36.00*
Gasket set
Four-part gasket set for the Quickly engine. Consisting of cylinder head gasket, cylinder base gasket, crankcase gasket and clutch cover gasket.

From €11.00*
Radial seal for shift shaft 3-speed
Radial seal ring shift shaft for 3-speed engines

€4.50*
Radial seal ring crank drive left
Oil seal for the left crankshaft sideis recommended for an engine overhaul!

€4.50*
Oil screw set (VA)
Oil drain plug + oil filler plug + oil check plug + 3 seals

€9.50*

Customers also bought

Clutch spring
Clutch spring, suitable for all engines, replace the spring when replacing the linings!

€5.50*
Carburettor gasket
Carburettor flange gasket approx. 8 mm thick

€4.80*
Clutch kit
Clutch set for 3 or 5 disc clutch from current production. No hardened old stock!

From €14.00*
Sealing ring for spacer tube (pedal)
Special sealing ring for bottom bracket axle for all models

€4.50*
Pedals (pair) with reflector
UnionPedals, old version,beautiful classic shape

€12.80*
Chain sprocket
suitable from vehicle no. 20694Chain sprockets with 12 teeth are standard for all models. Depending on requirements or use, however, sprockets with 11 teeth (good climbing ability) or 13 teeth (higher top speed) can also be fitted. The 14-tooth sprocket can only be used after modifying or adapting the housing or using a weaker, non-reinforced chain.

From €16.80*

Customers also viewed

Gasket set
Four-part gasket set for the Quickly engine. Consisting of cylinder head gasket, cylinder base gasket, crankcase gasket and clutch cover gasket.

From €11.00*
Gasket set complete
Complete gasket set with all housing gaskets, shaft seals and O-rings +manifold gasketfor 2 and 3-speed engines

From €34.80*
Stud bolt for cylinder
Stud bolts for cylinder mounting, galvanised - 4 pieces 7 required per engine

€4.00*
Chain sprocket
suitable from vehicle no. 20694Chain sprockets with 12 teeth are standard for all models. Depending on requirements or use, however, sprockets with 11 teeth (good climbing ability) or 13 teeth (higher top speed) can also be fitted. The 14-tooth sprocket can only be used after modifying or adapting the housing or using a weaker, non-reinforced chain.

From €16.80*
Overrunning set 2-speed engine FAG
Complete overhaul kit for the 3-speed Quickly engineConsisting of all bearings, brand make FAGall shaft seals, all O-rings + manifold sealing ring

€59.80*
Capacitor
Ignition capacitor different versions (for soldering or screwing) Capacitors are a frequent source of faults due to their age and should always be replaced

From €4.80*
Clutch cover gasket
Ausf.: 3-speed
Gasket for 2nd or 3rd gear engines Clutch side

€3.60*