Werkzeug

Adapter set for bicycle / car inner tubes

Air pump adapter set1 adapter from Dunlop to car1 adapter from car to Dunlop

€3.50*

Assembly tool for clutch basket inside

Special tool for easy assembly of the inner clutch basket

€14.80*

Assembly tool for piston clip

Assembly tool for piston C-clips 10mm (see illustration with the tool)Simplifies the installation of retaining clips without eyelets.A clip that is damaged during installation can come loose during operation and cause immense engine damage, which can be prevented by using this tool.Video

€14.80*

Bottom bracket axle filler piece

Ausf.: for new axle

for mounting bottom bracket axle/clutch cover

€3.00*

Dismantling lever for clutch cup

Assembly lever, required for various work on the engine (levering off the clutch cup, clutch basket etc.) Set with 2 levers

€18.00*

Feeler gauge

Feeler gaugefor setting the contact breaker and ignition13 sheets0.05 - 1mm

€8.90*

Holder for pole wheel and gear wheel

Special tool - makes installation on the engine easier!

€22.80*

Hook spanner for exhaust fitting

Suitable hook spanner for fitting the exhaust union nut

€11.50*

Ignition tuner

Easy-to-use ignition tuner Determine top dead centre, set pre-ignition - that's it! Screwed into the spark plug thread.

€36.00*

Mounting bracket for clutch spring

Special tool for easy assembly and disassembly of the clutch

€16.80*

On-board tool kit

6-piece - as original suitable for toolbox in the fork ( Quickly N,S, L, N23) or in the toolbox on the rear mudguard (Quickly F23, S23, S2-23).

€22.80*

Piston fastener

M 14 X 1.25 Is screwed in instead of the spark plug. Carefully push the piston against it and the crankshaft is blocked. Now you can work on the clutch and ignition without any problems and without the crankshaft turning

€7.80*

Puller for chain sprocket

Enables safe and trouble-free removal of all chain sprockets!

€14.80*

Puller for new ignition system

Suitable puller for our new ignition systems

€10.80*

Puller for pole wheel

Pole wheel puller for all Quickly motors Notes: Please note that the thread of the crankshaft must be protected by a brass pressure piece or similar if the pole wheels are stuck.Alternatively, the nut of the pole wheel can remain on the threaded stub.(loosen nut and turn flush to the end of the thread).

€8.80*